Descargar Imprimir esta página

Craftsman 917.377576 Manual Del Propietário página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

TO REMOVE
LAWN
MOWER
FROM
CARTON
1. Remove
loose parts included with
mower.
2.
Cut down two end corners
of carton
and lay end panel down flat.
3.
Remove
all packing materials
except
padding between
upper and lower
handle and padding holding operator
presence
control bar to upper handle.
4.
Roll lawn mower out of carton and
check carton thoroughly for additional
loose parts.
Operator
control bar
Lift
\
Mowing
position
Lower handle
HOWTO SET UP YOUR LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handles carefully so
as not to pinch or damage
control cables.
1. Raise handles until lower handle
section locks into place in mowing
position.
2.
Remove
protective padding,
raise
upper handle section into place on
lower
handle
and tighten
both handle
knobs.
3.
Remove
handle padding
holding
operator
presence
control
bar to
upper
handle.
Your lawn mower
handle can be adjusted
for your mowing
comfort.
Refer to "Adjust
Handle"
in the Service
and Adjustment
section
of this manual.
TO INSTALL
A'n'ACHMENTS
Your lawn mower was shipped ready to
be used as a mulcher.
To convert to
bagging or discharging:
• Open rear door and remove mulcher
plug.
Store mulcher
plug in a safe
place.
• You can now install catcher or optional
clipping deflector.
• To return to mulching operation,
install
mulcher
plug into discharge
opening
of
mower.
A, CAUTION:
Do not run your lawn
mower without mulcher plug in place or
approved clipping deflector or grass
catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open.
Mulcher
5
TO PREPARE BA'rrERY
NOTE: Your battery must be charged
before you can start your lawn mower.
1. Disconnect engine battery connector
(male) from battery connector (female)
2. Connect battery charger connector
(male) to battery connector (female).
3. Plug battery charger into 110 volt A.C.
outlet.
4. Leave battery charger connected for
24 hours before starting your engine
for the first time.
5. After charging, connect engine
connector (male) to battery connector
(female).
Your engine has an integral alternator for
partial charging.
Connect your battery
charger to charge battery as required.
IMPORTANT: The engine alternator will
not charge a discharged battery.
At the end of the mowing season the
battery should be charged for 48 hours to
protect the battery during winter storage.
_I=CAUTION: Always disconnect the
engine connector (male) from the battery
connector (female) to prevent accidental
starting when transporting or storing your
lawn mower after the season.
Engine
/,
connector
(M7 'elOr _/,,_.
___
,..... _
_
_k_ _ _,,,'_VJjr/_
uattery
_'!:::d t:__
°
- _W(:_R
\
charger
,,J"/_
connector
Battery connector (Female)
(Male)

Publicidad

loading