Unpacking Instruction; Power Supply; Front- And Backpanel - Vonyx WM82 Serie Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

FRONT- AND BACKPANEL

1. LCD Display
2. Volume Channel A
3. Volume Channel B
4. Power On/Off
5. 3-pin XLR Balanced output Channel B
6. 3-pin XLR Balanced output Channel A
7. Jack 6.35mm (¼") output connector
8. Power input (12V DC 1A)
9. Antenna
Models:
179.212 : WM82
179.214 : WM82B
UHF HANDHELD
Attention: If the microphone are not used for a longer period, please remove the batteries to prevent
damage in case of battery leakage!
4
UHF Microphone System 2 channel handheld microphone
UHF Microphone System 2 channel bodypack + headset
1.
Grille: Protects the cartridge and help reducing the breath sounds and wind noise.
2.
Display
3.
Power ON/OFF Switch.
4.
Low battery indicator: Red light glows when the power is low and change the battery.
5.
Battery Cover: Open it to install the battery. remove batteries in case of long time no use (prevent
leakage).