Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Electronic watch
Step 6:
1. According to the illustration, first insert the electronic watch (13) into the
picture and fix it in the corresponding card slot on the electronic watch holder (7).
2. Connect the heart rate sensor wires (20) to the corresponding connectors of
the electronic watch (13), and then connect the sensor wire of the main frame
(19) to ensure that the cushions are aligned before using the (21). The open-end
wrench is tightened. Connect with the corresponding connector of the electronic
meter (13). The installation and wiring of the electronic meter is as shown in the
figure below.
9
Publicidad
