Publicidad
Idiomas disponibles
Idiomas disponibles
The flat starter battery (car A) must not be sep-
arated from its corresponding power supply
network during the starting aid process.
The ignitions of the vehicles must be switched
off before the jump lead is connected, and the
parking brake must be engaged. With manual
gearboxes, put the gear lever into the neutral
position. With automatic gearboxes put the
gear selector into „P".
Position the jump leads in such a manner that
they cannot be caught up in the moving parts
of the engine.
Using the LED light
In poor lighting conditions, the LED lights
make connecting the jump leads easy.
To switch on the LED light
switch
to (I). To switch off the LED light
5
set the ON/OFF switch
Two button cell batteries are located in each
terminal. To replace these, remove the screws
which are affixed directly to the ON/OFF
switch
and remove the plastic cover.
5
Please note the polarity when inserting the
batteries (plus and minus poles) (see Fig.).
Using the jump leads
Connecting
EXPLOSION HAZARD! On no
account should you connect the
negative pole terminal (-) to the flat
battery as there is a risk that sparks may fly
and ignite explosive gases.
1. Connect the red jump lead
pole terminal (+)
1a
flat battery (A) an.
2. Connect the other pole terminal
jump lead
to the positive pole of the donor
1
battery (B).
Safety information / Using the LED light / Using the jump leads
4
set the ON/OFF
4
to (0).
5
with the red
1
to the positive pole on the
of the red
1b
3. Connect the black jump lead
pole terminal (–)
the donor battery (B).
4. Then connect the other pole terminal
black jump lead
on the earthing strap or another unpainted
part on the engine block of the broken-down
vehicle (A).
Note: The parts should be as far away as possi-
ble from the starter battery in order to prevent any
explosive gas that may develop from being ignited.
Note: If the green LED of the overvoltage protection
lights up, it means that this has been activated
3
and is functioning. The overvoltage protection ab-
sorbs any potential voltage peaks.
Starting
4
After you have connected the jump leads, first
switch on the engine of the vehicle with the
donor battery and bring it to average speed
(car B). Then start the engine of the broken-down
vehicle (car A).
Note: After every attempt to start the car - which
should not be longer than 15 seconds - wait for
at least 1 minute. If you cannot start the car after
several attempts, contact a garage.
A fter successfully starting the broken-down
vehicle (car A) wait for 2 to 3 minutes until the
engine is running smoothly.
Disconnecting
Note: Disconnect the jump leads in the reverse
order to the way they were connected.
1. Remove the pole terminal
lead
from the earth strap of the broken-
2
down car (A).
with the black
2
to the negative pole of
2a
of the
2b
to the vehicle chassis, e.g.
2
of the black jump
2b
GB/IE
17
Publicidad
