Publicidad
Idiomas disponibles
Idiomas disponibles
Controls
Item
Designation
03/8
03/9
03/10
03/11
03/12
5.3
Brake and clutch pedal (05)
■
Brake: Pressing the brake pedal (05/1) all
the way down operates the brake on the
transmission and the tractor is braked.
■
Parking brake: Pulling the parking brake le-
ver (05/2) upwards while the brake pedal
(05/1) is pressed down engages the parking
brake. Pressing the brake pedal again releas-
es the parking brake.
5.4
Transmission operation (driving speed)
(04)
Lawn tractors are equipped with a foot hydrostat
transmission.
Some models are equipped with cruise control.
There are two separate pedals on the right for
driving forwards and in reverse.
Direction
Description
of travel
Forwards Press the right pedal (04/2) to drive
forwards.
Reverse
Press the left pedal (04/1) to drive
in reverse.
Note: The mower mechanism is
switched off if just the reverse pedal
is pressed.
Mowing in reverse: see chapter
7.5.5 "Mowing with the lawn trac-
tor", page 41.
493723_a
The display lights up:
With the headlights switched on.
If the brake is applied and with the brake locked.
When there are only about 1.5 litres of fuel remaining in the tank.
If the oil level is below a particular level.
If the operator gets off the tractor with:
■
engine running (brake is locked)
5.5
The foot hydrostat transmission is operated by
two pedals (04/1 and 04/2).
To move off, first release the parking brake
(05/2) while the engine is running and then press
pedal (04/2) to drive forwards or pedal (04/1) to
reverse. The further you press the pedal, the fast-
er your speed will be in the selected direction.
Forward travel: Press the outer pedal (04/2) on
the right side.
Reverse travel: Press the inner pedal (04/1) on
the right side.
5.6
Setting the cutting height
The mower mechanism of the tractor can be set
to various different heights using a lever (06/2) on
the right next to the operator's seat.
1. Move the adjusting lever (06/2) in the desired
Switching on the mower mechanism
Switching on electrically: There is a switch (02/5)
in the area of the dashboard. Use this to switch
the mower mechanism on (i.e. to position "1").
Foot hydrostat transmission (04, 05)
Operating the mower mechanism (06)
direction. When the lever is down, the cutting
height is low; when the lever is up, the cutting
height is high.
37
Publicidad
