Tripp-Lite SmartPro SMART2200RMXL2U Manual Del Propietário página 5

Quick Installation
With the UPS disconnected from
1
utility power, use a small tool to
set the Voltage DIP Switches to
match your input voltage (UPS is
preset to the 120V setting).
Plug the UPS into an outlet on a
2
dedicated circuit.*
NOTE! after you plug the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries,** but will not supply power to
its outlets until it is turned ON (see Step 3 below).
* Includes an additional plug which can be switched by a qualified
electrician. ** The BATTERY CHARGE LED will be the only LED
illuminated.
Plug your equipment into the UPS.*
3
* Your UPS is designed to support only electronic equipment. You will
overload the UPS if the total VA ratings for all the equipment you con-
nect exceeds the UPS's Output Capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is listed in amps,
multiply the number of amps by 120 to determine VA. (Example: 1 amp
× 120 = 120 VA). If you are unsure if you have overloaded the UPS's out-
lets, see "OUTPUT LOAD LEVEL" LED description.
Turn the UPS ON.
4
Press and hold the "ON/OFF/STANDBY" button for
one second. The alarm will beep once briefly after one
second has passed. Release the button.
1
2
3
4
5