HANDLE POSITIONING FOR NORMAL OPERATION
The heater ships with the handle in a compact position that must be raised for normal operation (Fig. 1a)
• Grab handle and pull directly upward until the handle snaps into position.
• Do not lower the handle to the previous location. The "UP" position is the normal operating orientation.
TANK INSTALLATION INSTRUCTIONS
Tank Installation for DOT Certified 1 lb. Propane Cylinder(s) (Fig. 1)
• Open easy access tank compartment door(s). (On 18K Model Only)
• Locate regulator and swivel it upward by hand to provide better access for cylinder
• Attach cylinder(s) to swivel mount by gently turning clockwise until it is hand tight. Do not overtighten. Do not use tools to tighten.
• Check for gas leaks by using a 50% soap-water solution at the joint of the regulator and cylinder.
Handle in "shipped"
position
Fig. 1a - Handle Position
5
Handle raised to
operating position