Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Applications
Be certain the miter saw is mount-
ed or placed on a level, firm work
surface before using. A level and firm work surface reduces
the risk of the miter saw becoming unstable.
Workbench Permanent Attachment
1. Each of the four mounting holes (Fig. 27) in the tool
mounting pads (13) should be bolted securely using
5/16" (M8) bolts, lock washers and hex nuts (not in-
cluded).
Fig. 27
Mounting
Mounting
hole
hole
13
13
13
Mounting
Mounting
hole
hole
2. Locate and mark where the saw is to be mounted.
3. Drill four 5/16" (8mm) diameter holes through work-
bench.
4. Place the miter saw on the workbench, aligning holes in
base with holes drilled in workbench. Install bolts, lock
washers and hex nuts.
Alternate Attachment
Be careful not to over-drive nail or
over-torque the bolt. This could crack
foot or damage base.
The smaller mounting holes at each corner can be used for
nails or longer drywall screws.
The supporting surface where the saw is to be mounted
should be examined carefully after mounting to ensure that no
movement can occur during use. If any tipping or walking is
noted, secure the workbench or stand before operating the
miter saw.
Transporting and Mounting
Temporary Mounting Using Clamps
• If necessary, clamp the miter saw to a workbench or
table top.
• Place two or more "C" clamps on the clamping areas
(Fig. 28) and secure. There are clamping areas at all four
corners of the saw.
• Mounting with clamps may prevent access to some wide
miter angles.
Mounting
Mounting
Fig. 28
hole
hole
13
Clamping
Clamping
13
13
13
Mounting
Mounting
hole
hole
-29-
area
area
13
13
Clamping
Clamping
area
area
Clamping
Clamping
area
area
13
13
13
Clamping
Clamping
area
area
Publicidad
