Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 49
Watch while tilting to right
"30" position for
cutting 45° "spring
angle" crown molding flat
on table
Fig. 50
10
11
Saw Operations
Bevel scale information
"33.9" positions are for cutting 38° "spring
angle" crown molding flat on table
NOTE: Saw has a 33.9 detent feature to
automatically hold it at this bevel angle
setting
3. Adjust your left or right bevel stop indicator (33) to one
of the three pre-set locations, 33.9°, 45°, 47°, or tilt the
head assembly (Fig. 47, 28) until you reach the desired
angle on your bevel scale (Fig. 49 and Fig. 50, 10).
NOTE: To bevel the saw to the right, the Bevel Range Se-
lector Knob must be pulled forward (Fig. 50, 11).
4. Lock the bevel by rotating the bevel lock knob (34) coun-
terclockwise.
34
5. Follow either the procedure "Chop Cuts" on page 37
or "Slide Cuts" on page 38.
33
-41-
Watch while tilting to left
Publicidad
