Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
MAINTENANCE
Error codes
In the following cases the corresponding error
code indication appears. Follow the suggestions
below to solve the problem. If the error code
indication does not disappear, consult an AIWA
service center.
ERROROI The disc magazine is not properly
inserted in the CD changer. Reinsert
the magazine.
Refer to the
instruction manual for the CD
changer.
ERROR02 No CDs are loaded in the disc
magazine. Insert CDs properly.
Refer to the instruction manual for
the CD changer.
ERROR03 Focus error. Check that the discs
are loaded properly in the disc
magazine (right side up, etc.).
ERROR04 ProblemwiththeCDchanger. Reset
the unit by pressing the Reset button.
If this does not solve the problem,
consult an AIWA service center.
ERROR05 The CD changer is overheated.
Allow the changer to cool off by
moving the vehicle out of direct
sunlight.
Reset button
The Reset button is visible when you detach the
front panel. Try pressing this button if this unit or
the CD Changer (if connected) does not operate
properly. When you press this button, use the tip
of a pointed object such as a pencil or toothpick.
Note that all your settings stored in memory,
however, will be erased if you press this button.
Cleaning the front panel
When the front panel is soiled, wipe the surface
of the panel with a soft, dry cloth.
Cleaning the connector
The connector on the reverse side of the front
panel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
Publicidad
