Publicidad
Idiomas disponibles
Idiomas disponibles
or H05 VV-F". Check it before every use
for damage. Always uncoil it during use
because coiled cables can overheat.
Damaged extension cables should not be
repaired; they should be replaced with an
equivalent type.
■
Do not use the product if the electric cables
are damaged or worn.
■
If the power cord or extension cable
becomes damaged during use, disconnect
from the power supply immediately. Do not
touch the electric cables until the power
supply has been disconnected.
■
Make sure the power cord is positioned so
that it cannot be damaged by the cutting
means and will not be stepped on, tripped
over or otherwise subjected to damage or
stress.
■
Never pick up or carry the product by the
power cord.
■
Never pull by the power cord to disconnect
from the power supply.
■
Keep the power cord away from heat, oil
and sharp edges.
■
Make sure the voltage is correct for the
product. A nameplate on the product
indicates the product's voltage. Never
connect the product to an AC voltage that
differs from this voltage.
■
Make sure the switch is in Off position
before disconnecting from power supply.
PREPARATION
■
Wear full eye and hearing protection while
operating the product. If working in an area
where there is a risk of falling objects, head
protection must be worn.
■
Hearing
protection
operator's ability to hear warning sounds.
Pay particular attention to potential hazards
around and inside the working area.
■
Wear heavy long trousers, boots, and
gloves. Do not wear loose fitting clothing,
short trousers, jewellery of any kind, or use
with bare feet.
■
Secure long hair so it is above shoulder
level to prevent entanglement in moving
parts.
2
| English
may
restrict
the
■
Before use and after any impact, check that
there are no damaged parts. A defective
switch or any part that is damaged or worn
should be properly repaired or replaced by
an authorised service facility.
■
Make sure the cutting attachment is
properly installed and securely fastened.
■
Never operate the product unless all
guards, deflectors and handles are properly
and securely attached.
■
Consider the environment in which you are
working. Keep the working area free from
wires, sticks, stones and debris, which if
struck by the cutter, can become thrown
objects.
GENERAL SAFETY WARNINGS
WARNING
Read
all
safety
instructions. Failure to follow the warnings
and instructions may result in electric shock,
fi re and/or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool'' in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
WORK AREA SAFETY
■
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
■
Do not operate power tools in explosive
atmospheres, such as in the presence
of flammable liquids, gases or dust.
Power tools create sparks which may ignite
the dust or fumes.
■
Keep children and bystanders away
while operating a power tool. Distractions
can cause you to lose control.
ELECTRICAL SAFETY
■
Power tool plugs must match the outlet.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools. Unmodified
plugs and matching outlets will reduce risk
of electric shock.
■
Avoid body contact with earthed or
grounded surfaces, such as pipes,
warnings
and
all
Publicidad
