Publicidad
Idiomas disponibles
Idiomas disponibles
Accessory
Storage
Your accessories
may be stored in the
storage locations on the caster feet. The
hose may be stored by wrapping it
around the unit as shown.
Power Head
Y
Open
End of
Hose
tAccessory
Storage
Push Button
End of Hose
Operation
_.
WARNING:
To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important signs
indicating abnormal operation such as loss of suction, debris/liquid
exiting exhaust,
or abnormal
motor noises.
Immediately
stop using Vac if you notice these signs.
• Do not leave Vac plugged-in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vac in areas with flammable
gases, vapors or explosive dust in the air.
Sparks inside the motor can ignite airborne flammables.
Flammable gases and
vapors include:
lighter fluid, solvent-type
cleaners, oil-based paints, gasoline,
alcohol, or aerosol sprays.
Flammable
dusts include:
coal, magnesium,
aluminum,
grain, or gun powder.
• Do not vacuum up explosive dusts, flammable
liquids, or hot ashes.
• Do not use Vac as a sprayer.
,_
WARNING:
To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment.
Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Do not service Vac while it is plugged-in.
If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into water,
return it to an independent
service center or call customer
service.
• When using an extension cord, use only outdoor-rated
cords that are in good
condition.
Do not allow the connection
to come into contact with liquid.
• Do not vacuum toxic materials to reduce the risk of inhaling the vapors or dust.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power
cord into the
outlet,
turn the unit on by pushing
the
switch
from position
"O" to position
"1".
The symbols
used on the switch
actuator
are international
"On & Off" symbols.
"O"
is the symbol
for "OFF"
and "1" is the
symbol
for "ON".
© :OFF I
=ON
Publicidad
