Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
!
If the table is installed with a portion of the hose under the table,
the hose must be secured, so that no part of the hose will be
within 1" or come in contact with the underside of the burn pan
or where the hose will not be accidentally damaged or pinched.
Failure to secure the hose in a safe location may result in a gas
leak that could cause property damage, injury, or death. Follow
all other hose inspection instructions listed in this manual.
WARNING
!
Before using this fireplace, make sure you have read, understand, and are following all information
provided in this manual. Failure to follow these instructions could cause property damage,
serious injury, or death.
Checking for Leaks
1. Make a leak check solution by mixing 1 part dishwashing soap with 3 parts water in a spray bottle.
2. Make sure the control knob on the fireplace is in the "OFF" position, then connect your
fireplace to the LP gas tank and turn the tank's valve on.
3. Spray the leak solution on the valve connections, paying particular attention to the areas
indicated by arrows in the diagrams below.
4. If bubbles appear, turn the LP gas tank o , disconnect the tank, and inspect all connections,
making sure threads are clear of debris. Reconnect the LP gas tank and retest. If you continue
to see bubbles, turn the LP gas tank o . Disconnect the hose and call Real Flame Customer
Service at 1-800-654-1704 for assistance.
5. If no bubbles appear after 1 minute, wipe away excess leak solution and proceed to
"Lighting Instructions."
Pay close attention to the areas indicated by the arrows.
ASSEMBLY INSTRUCTIONS
PRE-USE INSTRUCTIONS
9
The hose should not come within 1"
from the bottom of the burn pan.
1"
Publicidad
