Publicidad
Idiomas disponibles
Idiomas disponibles
• Operate the radiator only in a ver� cal posi� on, otherwise it is dangerous to use it.
INSTALLATION
1. Place the radiator body upside down in a place that cannot be scratched. Make sure
it is stable and does not fall.
2. Unscrew the wing nuts from the provided u-bolt, a� ach the u-bolt to the fl ange
between the fi rst and second fi ns (near the front cover).
3. To a� ach the wheel moun� ng plate to the radiator body, you must insert the threaded
ends of the U-bolt into the holes in the wheel moun� ng plate.
4. Screw the wing nuts back onto the U-bolt and � ghten them properly. Note: Do not
over� ghten as this may damage the radiator fl ange.
5. Unscrew the ball nut from the wheel, align the axle with the hole in the wheel
moun� ng plate, insert and screw the ball nut.
6. Repeat steps 2, 3, 4 and 5 at the rear of the radiator to mount the rear wheels. Note:
the rear wheels must be mounted between the two end wings.
OPERATION
1. Before using the radiator, make sure it is on a fl at and stable surface; damage may
occur if placed on a slope.
2. Turn all controls to the off posi� on and insert plug into a grounded electrical outlet.
Make sure the plug fi ts fi rmly.
3. Turn the thermostat knob clockwise to the MAX posi� on. Then turn the power switch
to posi� ons I, II or III depending on the desired temperature (I for the minimum
temperature, III for the maximum).
4. When your room reaches the desired temperature, slowly turn the thermostat
knob counterclockwise un� l the indicator light goes out. The thermostat can now
be le� in this se� ng. As soon as the room temperature has dropped below the set
temperature, the radiator will automa� cally switch on un� l the set temperature
is reached again. In this way the room temperature is kept constant using a more
economical electricity consump� on.
5. If you want to change the room temperature se� ng, turn the thermostat knob
Publicidad
