HEBU medical GOLD II Instrucciones Para El Uso Y El Servicio página 22

EN
3. Position the fixing ring. The notches in the fixing ring must always be pointing towards
the saw (see fig. 2). These must also be positioned precisely on the spigots.
4. Screw the retaining screw in manually until hand tight.
5. Then tighten firmly using the fork wrench, as described above.
The tightening torque is 6 - 7 Nm. Caution! Do not overtighten.
6 Operation
Switching on and off (see fig. 3)
Switching on: Push the switch forwards
Switching off: Push the switch back
Setting the oscillating frequency (see fig. 4)
Select the oscillating frequency when the motor is running.
The optimum oscillating frequency can be selected at the s
peed gauge depending on the properties of the plaster cast.
Oscillating frequency preselection using the electronic
speed gauge.
Lowest oscillating frequency
Highest oscillating frequency
22
Inserting the saw blade
( I )
( 0 )
( 1 )
( 8 )
Oscillo-Saw GOLD II
Fig. 2:
O
I
Fig. 3
Fig. 4