Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
1. Open the package and insert the battery pack into the battery pack inserts.
3. The buzzer sounds 2 times when the power is first turned on; pull the trigger twice continuously to get into
the activated state.
4. Normal pruning: Press the trigger and then the blade will close. Release the trigger and then the blade
will open. Blade closed: Keep pressing the trigger and when the buzzer rings for long, the blade is in the
closed state.
5. Before start, press the trigger at intervals to close the blade without any load for several times and check if
it is normal.
6. Start working after checked normal.
After use,
1. Keep pressing the trigger, the buzzer will ring for long, release the trigger and then the blade will not open
and no longer open.
2. Turn off the power source and remove the battery pack.
3. Clear up, clean and pack.
Icnodcaesoenotfhaendyifsapulalty, psclereaesen.handle it according to the prompt
Fault prompt on the display screen:
When using this product, if the following code appears on the screen, repair or handle according to the
corresponding fault prompt.
Alarm content
No fault
Anti-hand cutting protection
Current sensor error
MOS tube damage
Hall fault/blade breaking
Peak overcurrent/average current
protection
Meanings of Shears Alarms
The mainboard's
The mainboard's
LED flashes for
BUZ rings for
several times.
several times
0
1
2
3
4
5
Display fault of
the LED
0
E00
1
E01
6
E02
6
E03
3
E04
5
E05
EN
Other
Instructions
43
INSTRUCTIONS
Publicidad
