Publicidad
Change the Sear burner Orifice
1. Use a wrench to remove the sear burner orifice brass
connector with flex line end to sear burner tube.
28
All manuals and user guides at all-guides.com
2. Use 6 mm socket wrench or 6 mm nut driver to remove the
orifice. Replace with the Natural gas orifice.
IMPORTANT: Check that the LP orifice is properly removed
inside of the valve.
3. Reinstall sear burner, tighten the sear burner orifice brass
connector and sear burner tube by using a wrench.
4. Open the manual shutoff valve in the gas supply. The valve
is open when the handle is parallel to the gas pipe.
5. Test all connections using an approved noncorrosive leak-
detection solution. Bubbles will show a leak. Correct any
leak found
Publicidad
