Plug the power cord into the nearest outlet. Make sure the surface is dry (never place
Airfree
on wet floor or immerge it in water). Make sure the On/Off led is on. Adjust
®
the Night Light intensity with the touch sensor. After 30 minutes the top lid should be
warm.*
Place Airfree
on a flat surface preferably not exceeding 30' / 75 cm from the floor, not
®
under furniture, shelves, or behind curtains as it will interfere with air flow and Airfree
efficiency in destroying microorganisms.
Check if the area is compatible with the unit capacity to achieve best unit performance.
Using Airfree
in rooms larger than its capacity will greatly reduce its purifying
®
capacity.
Airfree
must be continuously on in the same room, 24 hours a day. Nevertheless,
®
temporarily removing it from the room will allow new microorganism contamination to
grow but it will be destroyed when Airfree
without Airfree
the higher the new contamination in the room.
®
Airfree
is to be used preferably in rooms larger than 43 sq. ft. or 353 cu. ft. / 4 m² or
®
10 m³.
Rooms with air condition or ventilation will not affect the air sterilization efficiency of
your Airfree
. Same for Heating systems.
®
Airfree
can be placed in corridors but the air sterilization effects will barely have any
®
effect in connecting rooms.
Avoid place the unit near open doors or windows to prevent some of the sterilized air
to exit the room.
SHORT POWER CORD INSTRUCTIONS
- A short power supply cord is provided to reduce the risk resulting from becoming
entangled in or tripping over a longer cord.
- Extension cords are available and may be used if care is exercised in their use.
- If an extension cord is used, the marked electrical rating of the extension cord should
be at least as great as electrical rating of the appliance, and the longer cord should
be arranged so that it will not drape over the counter or table top where it could be
pulled on by children or tripped over unintentionally.
Installing and Connecting
®
5 5
is plugged in again. The longer the period
®