Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
appliance will not operate until the water inside the tank is drained.
Manual drainage. Fig. 10
Place a container below the water outlet behind the body.
1.
2.
Unscrew the drain cap and unplug the water plug. The water will automatically flow into
a container.
NOTE:
-
Move the device carefully, so as not to spill the water in the water tank at the bottom of
the body.
-
Keep the drain cap and the water plug properly.
During drainage, the body can be tilted slightly backwards.
-
-
If the water container cannot hold all the water, before the water container is full, stuff the
water outlet with the water plug as soon as possible to prevent water from flowing to the
floor or the carpet.
When the water is discharged, re-tighten the water plug and tighten the drain cap.
-
-
Restart the appliance after the plug and cap are installed, otherwise condensed water of
the appliance will flow to the floor or the carpet.
Continuous drainage. Fig. 11
1.
Unscrew the drain cap and unplug the water plug.
2.
Set the drainage pipe into the water outlet.
3.
Connect the drainage hose to a bucket or big container.
Protection features:
Frost protection function
In cooling and dehumidification modes, if the temperature of the evaporator outlet pipe is
too low, the appliance will automatically enter protection mode to prevent damage to the
evaporator. The appliance will restart when the temperature is restored to normal values.
Condensate water flooding protection function
When the water level exceeds the maximum level allowed by the safety buoy, the appliance
will switch off and activate the FL indicator on the control panel. To restart the device, the
water inside the device will need to be drained through the bottom drain plug (shown in detail
in the drainage instructions section). Once the water has been drained, the device will restart.
Automatic defrost
This air conditioner has an automatic defrost function.
66
FORCECLIMA 12600 SOUNDLESS HEATING
Compressor protection function
To increase the service life of the compressor, it has a 3-minute delay booting protection
function after the compressor is turned off.
5. CLEANING AND MAINTENANCE
-
Turn off and unplug the device from the power supply before cleaning or repairing it.
Use a soft, dry (or slightly damp) cloth with some neutral cleaning agent to clean the
-
product's outside and prevent the accumulation of dust and dirt.
-
If the product is not going to be used for a long time, store it in a safe and well-ventilated
place.
Do not use detergent, scouring pads, chemically-treated cloths, petrol, benzene, alcohol,
-
thinner, or other solvents, as these can scratch and damage the tank and cause water
leakage.
-
Do not immerse the product in water or other liquids.
Cleaning the fitler. Fig. 12
-
If the filter is clogged with dust, the effectiveness of the air conditioning will be reduced.
Make sure to clean the filter once every two weeks.
Cleaning the upper filter frame
-
-
Unscrew the screw attached to the filter at the rear with a screwdriver and remove the
filter.
-
Put the filter screen into warm water with neutral detergent (about 40 ºC / 104 ºC) and
dry it in the shade after rinsing clean. Make sure it is completely dry before reattaching it.
Replacing batteries
The remote control is powered by two AAA batteries. If the remote control does not respond,
replace the batteries as follows:
1.
Put the remote control face down and slide the tab outwards.
2.
Remove the batteries.
3.
Insert the batteries paying attention to polarity.
Storage
-
Store the device in well ventilated areas.
-
Unscrew the drain cap, unplug the water plug, and discharge the water in the water tank
into other water containers or directly tilt the body to discharge the water into other
containers.
-
Turn on the appliance, adjust it to low-wind ventilation mode, and maintain this state until
the drainage pipe becomes dry. This way, you will keep the inside of the body in a dry state
ENGLISH
FORCECLIMA 12600 SOUNDLESS HEATING
67
Publicidad
