cecotec CONGA ROCKSTAR NONSTOP WET Manual De Instrucciones página 27

ENGLISH
6. CLEANING AND MAINTENANCE
- Always turn off and unplug the vacuum cleaner before cleaning or maintenance.
- Use a soft, slightly dampened cloth to clean the device's surface.
Never immerse the device in water or other liquids. Do not allow liquids to enter the device.
-
Do not use abrasive cleaners or scouring pads to clean the product.
-
- Do not leave the vacuum cleaner in a place with direct sunlight.
- Do not leave the vacuum cleaner in a wet place after cleaning it.
After the brush has been used for a long time, bristles might start to tangle with hair and
-
other particles. Clean it for it to operate correctly again.
Filters and tank cleaning
To prevent the appliance from overheating and losing suction power, it is suggested to
-
clean the filters frequently. To make the most of the suction power, it is suggested to clean
the filter after every use.
- The filters shelf life will depend on the accumulated use and the type of particles which are
frequently vacuumed. It is recommended to replace the filters every 6 months.
To remove the main filter:
1. Press the dirt-tank and filter access release buttons, turn clockwise to remove the filter
system.
Once the filtering system is out, turn the metallic handle anticlockwise and you will be
2.
able to take the high-efficiency filters out.
To remove the upper filter:
Turn the top cover counterclockwise.
1.
2. Remove the fabric filter.
Vacuum and shake the filters to remove every particle and dust remain that may block
-
them and difficult the correct air circulation. Remember not to use the vacuum cleaner
without the filters properly assembled.
- Filters cannot be washed inside a washing machine nor dried with a hair dryer.
Do not brush the high-efficiency filter.
-
To empty the dust tank:
1. Press the dirt tank's release button.
2. Once the cover is open, it can be emptied.
Cleaning the Jalisco brush. Fig. 5
1. Move the rotary-brush release button with the finger toward the arrow of Figure 5 and
remove the cover on the same side of the brush.
52
2. Remove one brush's ends as shown in Figure 5.
- It is important to clear and clean all the residues left in the brush's rotary axis.
If you decide to wash the brush, you must air dry all the pieces. Assemble the pieces back
-
to use the brush again.
How to remove the battery
Press the battery release button and remove the battery as shown in figure 3. Store the battery
in a plastic bag and leave it in a dry place.
Vacuum cleaner storage
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
7. TROUBLESHOOTING
Problem Possible cause
The vacuum cleaner does not Battery is discharged.
work. The suction tube, brush,
battery, or the appliance
itself are not correctly
positioned.
The suction power The dirt tank is full.
decreased, and the vacuum The filters are too dusty.
cleaner makes a lot of noise. The brush inlet is
obstructed, or the brush is
blocked.
Insufficient operating time Insufficient charge time.
after charging the vacuum Battery life has been
cleaner. exceeded.
(The battery life may vary
according to the room
temperature).
8. TECHNICAL SPECIFICATIONS
Product reference: 05861
Product: Conga Rockstar NonStop Wet
Motor rated power: 200 W
Brush rated power: 15 W
Charger output: 26.4 V 0.5 A
ENGLISH
Solution
Charge the vacuum cleaner.
Make sure all parts of the
vacuum cleaner are correctly
assembled.
Clean the dirt tank.
Clean or replace both filters.
Clean the dirt from the brush
inlet.
Fully charge the battery
following the instructions in
this manual.
Batteries are easily recycled.
Go to the closest maintenance
point and buy new batteries.
53