cecotec CONGA ROCKSTAR 1600 X-TREME Manual De Instrucciones página 27

ENGLISH
How to remove the battery
Press the battery release button and remove the battery as shown in Fig. 11. Store the battery
in a plastic bag and leave it in a dry place.
Device storage
Remove the battery and store it in a safe, dry place if the device is not going to be used in a
long period of time.
Maintenance indicator
The full tank icon or the clogged filter icon will be displayed if the device has not been properly
and frequently maintained. Fig. 12-13
6. TROUBLESHOOTING
Problem Possible cause
The motor does not The battery does not work
operate any longer.
The metallic tubes, floor
brushes, batteries or the
device itself are not properly
assembled.
The suction power The dust tank is full. Fig. 12
has been reduced The filter has too much dust.
and the appliance Fig. 13
makes a lot of The electric rotary brush inlet
noise. is clogged or the brush is
blocked. 14
Insufficient Insufficient charge time.
operating time The battery is old.
after charging the
device.
(The battery life
may vary according
to the room
temperature).
52
Solution
Charge the vacuum cleaner.
Make sure all parts of the device are
correctly assembled.
Clean the dirt.
Clean or replace the filter.
Clean the dust inside the electric
rotary brush.
Fully charge the battery following
the instructions in this manual.
Batteries are easily recycled. Go to
the closest maintenance point and
buy new batteries.
7. ERROR CODES
Code Problem
E1 The device turns off and
does not charge.
E2 The device does not
charge.
E2 The device does not
charge.
The device turns off.
E3 The device turns off and
displays E3.
E5 The device turns off and
displays E5.
E6 The device turns off and
displays E6,.
E9 The device turns off and
displays E9.
E7 The device stops working
or does not turn on and
shows E7.
E8 The device turns off and
displays E8.
High-efficiency The device stops or does
filter indicator not switch on. Fig. 13
blinks
The filter set It works normally. Fig. 12
logo flashes.
The brush icon The long brush and motor
flashes stop working. Fig. 14
ENGLISH
Cause
Short circuit
The charger's voltage is below 36.3 V
The charger's voltage is below 32.1 V
Low battery
The motor short-circuits when the
battery is low
Main motor overload (second level)
Main motor overload
Temperature too high or low
Battery fault (first level)
NTC error (thermistor short circuit)
High-efficiency filter not installed
The dust tank or the inlet filter is blocked
Blocked long brush
Long brush full of hair
CONGA ROCKSTAR 1600 X-TREME 53