Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
-
It's recommended to use a high power level in presence of a lot of dirt or liquids on the
floor.
Charging the appliance.
-
Place the appliance on the charging base so as to insert it in the base connector.
-
The battery indicator will stay red during charging and will change to white when charging
is complete.
When using the electric mop for the first time, the battery may not be fully charged. Completely
charge the battery before first use.
Auto-clean function. Fig. 9
Before the auto-clean cycle:
1. Make sure the water tank is filled. If not, fill it up.
2. Place the appliance on the self-cleaning base.
3. Press the auto-clean button to start the programme: the display will show the duration of
the auto-clean cycle.
4. After the auto-clean cycle, the appliance will switch off automatically.
5. Remove, empty, and clean the clean water and waste-water tank after each auto-clean
cycle.
Note:
1. Before and after using the auto-clean function, empty the waste-water tank.
2. If the waste-water tank is full during the auto-clean process, you will be prompted and
auto-clean will stop automatically.
3. This mode is designed to prevent the wet rotary brush from producing bacteria or
unpleasant odours.
Base Drying Mode
Place the electric mop on the self-cleaning base and hold the mode selector for 3 seconds
to enable Drying Mode. This mode will be automatically enabled after each auto-clean cycle.
The duration of Drying Mode is 4 hours at a time.
If after enabling Drying Mode you lift the appliance from the charging base and put it back on,
Drying Mode will not be enabled automatically.
Note:
Drying Mode has no memory function, so if you disable and re-enable it, the time will be reset.
50
5. CLEANING AND MAINTENANCE
-
Make sure the appliance is not plugged to a mains socket before cleaning it or carrying out
maintenance on it.
-
Make sure the charging base is not plugged to a power outlet before cleaning it
-
Be sure to remove the battery to prevent the electric mop from accidentally turning on
during cleaning.
Cleaning the waste-water tank. Fig. 10
When the waste-water tank is full, the light indicator will flash, and the appliance will switch
off. When this happens:
1. Once switched off, remove the tank as indicated in section "3.Product installation" and
empty it.
2. Pull the filter out of the filter housing to remove it from the wate-water tank as shown in
Figure 10.
3. Rinse the waste-water tank, filter grille, and filter with clean water.
4. After cleaning it, re-install the waste-water tank in the appliance. You can then resume
use.
Note:
After each use, it is recommended to clean the waste-water tank immediately.
If the water-level detection sensor is dirty, it can be cleaned with a cloth or rinsed with water
and then wiped with a cloth.
Cleaning the floor brush assembly
1. Remove the rotary brush cover and the rotary brush as described in section "3.Product
installation".
2. Use a dry cloth to clean the rotary brush area.
3. Clean the cover and the rotary brush with water.
4. After rinsing, place the rotary brush and cover back in position as described in section
"3.product installation".
Tips:
When storing the appliance, make sure that it is clean and dry by drying the filter, filter housing,
tanks, and rotary brush in a well-ventilated place. This will prevent unpleasant odours caused
by bacteria and dampness.
Maintenance and storage
-
Clean the waste-water tank, filters, rotary brush, and its cover after each use.
-
When the waste-water tank fills up during operation, empty it immediately so that it does
not affect the correct operation of the appliance.
ENGLISH
FREEGO WASH&VACUUM SPRAY
51
Publicidad
