Descargar Imprimir esta página

cecotec HYDROBOOST 1400 EASYGO Manual De Instrucciones página 73

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 62
ENGLISH
Spray mode
Turn the spray nozzle to select the fan spray pattern to cover large areas. This cleaning mode
offers excellent results without the risk of damaging surfaces. By using a wide spray pattern,
larger areas can be cleaned more quickly. Fig. 4
Turbo mode
Use the 3D TurboFlip nozzle to clean with a turbo mode. Water is distributed in a spiral-
shaped jet. The 3D TurboFlip nozzle combines the power of a direct jet of great impact with the
efficiency of a 25º jet. This transforms the concentrated jet into a conical jet that deep cleans
larger areas. Fig. 5
Product performance
Note
The motor of this pressure washer does not run continuously. It only runs when pressing the
trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
High-pressure hose angle based on surface
When spraying water against a surface, the jet achieves maximum impact when sprayed
head-on. However, this type of impact tends to embed dirt particles into the surface, creating
the opposite cleaning effect to the one desired. Therefore, the optimum angle for spraying
water against a surface is 45°. Spraying water at this angle improves the impact and allows for
a more efficient removal of dirt. Fig. 6
Distance from the surface to be cleaned
Another factor that determines the impact force of the water is the distance from the surface
to be cleaned. The impact and force of the water increases as the spray nozzle approaches the
surface.
How to avoid damaging surfaces
A surface is damaged when the water impact force is greater than the hardness of the surface.
The impact force will vary according to the settings mentioned above. Never use a direct jet
on surfaces susceptible to damage. Avoid spraying windows with the direct jet, as they may
break.
The best way to avoid damaging surfaces is to follow these steps:
1. Before pressing the trigger, move the spray nozzle to the fan spray position.
2. Follow the distance and angle instructions mentioned above.
3. Vary the angle of the jet, the type of jet, and the distance from the surface to be cleaned
until efficient cleaning is achieved without damaging the surface.
73
HIDROBOOST 1400 EASYGO

Publicidad

loading

Este manual también es adecuado para:

08136