cecotec CONGA ROCKSTAR DEEPCLEAN ESSENTIAL Manual De Instrucciones página 25

ENGLISH
- Handheld vacuum cleaner, attaching the accessories directly to the main body.
- Upright vacuum cleaner, using the vacuuming tube with the accessories assembled.
Using the vacuum cleaner
- Press the power button to turn the vacuum cleaner on or off.
- Press the speed dial repeatedly to select the device's operating speed: Eco and Turbo. The
device will turn on in Eco mode by default.
Attachments
This device includes different accessories that allow cleaning different types of surfaces,
objects, and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
2 in 1 accessory
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it.
Accessory for corners
This accessory is preferably used with the handheld vacuum cleaner to reach less accessible
dirt in corners.
Installing the wall bracket
Fig. 5
1. Place the wall bracket on the wall and mark the points where the holes are to be drilled
to fix the bracket. It is important that the suction base rests on the floor so that the wall
bracket does not support the full weight of the vacuum cleaner.
2. Drill the 3 holes (previously marked) and insert the pegs and screws.
3. Make sure that the charging base is securely fixed to the wall and place the vacuum
cleaner on the bracket, inserting the charging terminals of the vacuum cleaner into the
charging terminals of the bracket (plastic tab).
4. Once the wall bracket is installed, connect the power adapter to the charging port, and
then you can charge the vacuum cleaner by simply sliding it up and down the wall bracket.
Charge and display
- The battery must be charged with the wall bracket while it is connected to the main body.
Plug one end of the adapter into the power supply and connect the other end to the bracket.
- During charge, the battery indicator will flash. When charging is complete, the battery
indicator will remain steady.
- You can also charge the battery without using the wall bracket. You can charge the battery
when the battery is installed or not in the vacuum cleaner. Connect the adapter and connect
the other end to the battery, paying attention to the direction. Once properly connected,
48
CONGA ROCKSTAR DEEPCLEAN ESSENTIAL
the battery indicator will flash and change to steady when charging is complete.
5. CLEANING AND MAINTENANCE
- Turn the appliance off, unplug it from the power socket, and allow it to cool down before
cleaning it.
- Use a soft, slightly dampened cloth to clean the surface of the device.
- Never immerse the device in water or other liquids. Do not allow liquids to enter the device.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Do not leave the vacuum cleaner in a place with direct sunlight.
- Do not leave the vacuum cleaner in a wet place after cleaning it.
- After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it in order for it to operate correctly again.
Filters and tank cleaning
- To prevent the appliance from overheating and losing suction power, it is suggested to
clean the filters frequently. To make the most of the suction power, it is suggested to clean
the filter after every use.
- The filter's shelf life will depend on the accumulated use and the type of particles which
are frequently vacuumed. It is recommended to replace the filters every 6 months.
- To remove the main filter:
1. Press and move the dirt tank opening button,
2. Once the dirt tank has been removed, remove the high-efficiency filter.
- Vacuum and shake the filter to remove every particle and dust remain that may block them
and difficult the correct air circulation. Remember not to use the vacuum cleaner without
the filter properly assembled.
- Filters cannot be washed inside a washing machine nor dried with a hair dryer.
- Do not brush the high-efficiency filter.
- To empty the dust tank, press the dust tank lower-cover opening button, open it and empty
it.
Mixed brush cleaning
Fig. 6
- Move the rotary brush release button with the finger and remove the cover on the same
side of the brush.
- Take one end of the brush out as shown on the image.
- It is important to clear and clean all the residues left in the brush's rotary axis.
- If you decide to wash the brush, you must air dry all the pieces. Assemble the pieces back
in order to use the brush again.
ENGLISH
CONGA ROCKSTAR DEEPCLEAN ESSENTIAL
49