ENGLISH
Loosen the clips.
Raise the head assembly from the dust tank.
Install the high-efficiency filter and press it tightly on the bottom cap basket.
Place the hose assembly on the dust container that already has a filter assembly and lock it
with both sides of the clips.
Open the battery cover. Do this by swinging up the cover. Then insert the battery and push it
down until you hear the battery engage.
Replace the battery cover.
Align the hose assembly port with the suction port, and then rotate it clockwise and insert it.
Optionally, three tube and hose assemblies can be installed.
Press the switch.
Start vacuuming.
Warning: Be sure to read, understand, and apply information, entitled 'safety instructions
& warnings'. Do not vacuum in areas with flammable gases, vapours, or explosive dusts in
the air. Flammable gases or vapours include but are not limited to; lighter fluid, solvent type
cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are
not limited to; coal, magnesium, grain or gun powder. To reduce the risk of health hazards from
vapours or dust, do not vacuum toxic materials.
Emptying the dust tank
Fig. 7.
When the dust tank is full:
Turn off the switch.
Release the buckle.
Raise the hose assembly from the dust container.
Pour out the garbage.
Water cleaning
Fig. 8.
Cover the bottom cap basket with watering absorbing sponge, make sure it covers the whole
basket.
Place the head assembly on the dust container and lock it with both sides of the clips.
Press the switch.
Install the required suction accessories on the hose assembly.
When the water is absorbed to the maximum capacity, the safety valve operates. The suction
port has no suction, turn off the power.
Pour water out.
To ensure the best results of water absorption, please remove the air filter sponge, hand-
wring dry after drainage.
Wash the sewage sponge with clean water and hand-wring dry after washing before using it
39
CONGA ROCKSTAR 2000 WET&DRY LIBERTY