LG DLEX3700 Serie Manual Del Propietário página 42

42 OPERATION
Rack Dry (On Some Models)
Use the Rack Dry function with items, such as wool
swearters, silk items, and lingerie, that should be
dried flat. Rack Dry can also be used with items that
should not be tumbled dry, such as gym shoes or
stuffed animals.
NOTE
• NEVER tumble dry a load of clothing with the rack
installed.
• When the rack is installed, the drum will rotate as
usual, but the rack will not move. Make sure all
articles to be dried remain completely on the rack
and cannot fall off or be pulled off by the turning
drum. Be sure to remove the rack after use.
Using the Rack Dry Cycle
1
With the dryer door open, slide the rack into
the dryer drum.
2
Make sure it is seated evenly on the edge
of the inner door rim and resting flat on the
inside of the dryer.
3
Place wet items on the rack. Allow space
around the items for air to circulate.
4
Close the door and select Rack Dry.
5
Press Temp. to select a temperature option.
If no temperature is selected, Rack Dry
defaults to no heat.
Special Functions
Some cycle option buttons also activate secondary
functions. These special functions are marked with an
asterisk (*). Press and hold the option button marked
with the special function to activate it.
Control Lock
Use this option to prevent unwanted use of the dryer
or to keep cycle settings from being changed while
the dryer is operating.
Activating the Control Lock Function
Press and hold the Wrinkle Care button for 3
seconds.
The Control Lock icon will be shown in the display,
and all controls will be disabled except the Power
button.
Deactivating the Control Lock Function
Press and hold the Wrinkle Care button for 3
seconds.
Once set, Control Lock remains active until it is
manually deactivated. Control Lock must be turned
off to run another cycle.
Custom PGM
Save special combinations of settings that are used
frequently as a custom program.
Saving a Custom Program
1
Turn on the dryer and select the desired settings
using the cycle selector knob and cycle modifier
or option buttons.
2
Press and hold the Custom PGM button for
three seconds.
NOTE
• Only one custom program can be saved at a time.
Pressing and holding the Custom PGM button will
overwrite any previously saved custom program.
Recalling a Custom Program
1
Turn on the dryer and press the Custom PGM
button.
2
Press the Start/Pause button to start the cycle.
Default On/Off
This option allows the Energy Saver settings to be
changed. To run a Normal cycle without the Energy
Saver option, press and hold the Energy Saver
button for three seconds. ON or OFF appears in the
display.