Publicidad
Idiomas disponibles
Idiomas disponibles
Elliptical machine
ES EN
ATLAS
5. ASSEMBLY INSTRUCTIONS
STEP 1 - Unpack the rear part and carefully remove the parts. According to the parts drawing on page 3,
assemble the two rear stabilizers(2) and the main frame (1) with the curved washer 8MM(7) of the carriage
bolt M8*60 (8), then tighten them with a wrench. 8MM(7) curved washer of the M8*60 carriage bolt (8),
then tighten them with a spanner.
STEP 2 - Adjust the tension knob (38), then connect the lower sensor cable (33) to the upper sensor cable
(34), and the lower tension hook (35) to the upper tension hook (36) according to the mounting bracket.
Using the 8MM curved washer (7), 8MM lock washer (52) and M8*15 bolt (32) assemble the front post (37)
to the main frame (1), then tighten with the spanner.
Publicidad
