Publicidad
Idiomas disponibles
Idiomas disponibles
Elliptical machine
ES EN
ATLAS
STEP 7 - Connect the pulse cable (53)
from the computer (40) and the pulse
cable (50) from the fixed handlebar (45).
Place the appropriate batteries in the
battery case. Mount the computer
(40) and the front post (37) with the
M5*10 screw (39) and the end cap,
then tighten them with a spanner.
6. MONITOR OPERATION
MODE - Press down to select functions. Press down to reset time, distance and calories for 2 seconds.
SCAN: Press the MODE button until "SCAN" appears, the monitor will rotate through the following functions:
time, speed, distance, calories and pulse, each display will be held for 6 seconds.
TIME: Count the total time from the start of the exercise to the end.
SPEED: Displays the current speed.
DISTANCE / CALORIES: Counts the distance / calories from the start of the exercise to the end.
PULSE: measure heart rate. Hold the two heart rate sensors in both hands to measure heart rate.
Note: During the process of pulse measurement, due to the jamming of the contacts, the measurement
value may be higher than the virtual pulse rate for the first 2~3 seconds, then it will return to the normal
level. The measurement value cannot be considered as a basis for medical treatment.
Notes:
1. If the battery symbol on the display is illuminated,
please replace the battery.
2. The monitor will automatically turn off if no signal is
received after 2 minutes and will automatically turn on
when it starts to exert the input button signal.
3. When you stop exercising for 4 seconds, the display
will stop calculating and a "STOP" will be shown on the
display. When you start exercising again, the display
will start calculating automatically and the "STOP" will
disappear.
Publicidad
