Toparc NUM-3 Manual Del Uso página 7

User manual
WARNINGS - SAFETY RULES
GENERAL INSTRUCTION
These instructions must be read and understood before any operation.
Any modification or maintenance not indicated in the manual must not be undertaken.
The manufacturer shall not be held liable for any personal injury or material damage caused by use not in accordance with the instructions in this
manual. In the event of a problem or uncertainty, consult a qualified person to handle the installation correctly.
This manual describes the wiring of this product. Any user who does not strictly comply with the safety instructions described in this manual may
be exposed to electrical risks and/or a serious or even fatal accident.
ELECTRIC SAFETY
During any intervention on the product, make sure to secure the area by keeping at a distance any person who has not read the instructions of safety
described in this manual. This product should preferably be installed by a professional in accordance with the installation rules in force in the country.
If not, it is recommended that you read these rules before working on it.
PRECAUTIONS AGAINST ELECTROSTATIC DAMAGE
Static electricity can damage electronic equipment. Use a grounded anti-static wrist strap, an ankle strap, or equivalent safety device
to prevent electrostatic damage (ESD) when installing this product.
Electrostatic damage can irreparably damage the generator and/or the product. To protect electronic components from electrostatic damage, place
this product on an antistatic surface, such as an antistatic discharge mat, antistatic bag, or disposable antistatic mat.
INSTALLATION - USING THE PRODUCT
DESCRIPTION
The digital Kit NUM-3 (ref. 081246) allows an additional application on compatible MIG/MAG and TIG welding machines. It allows to add a digital
remote control (ref. 079700).
Welding machine compatibility:
KRONOS 400T G 075054
ARKAD 400T G 075535
KRONOS 400T GW 075061
ARKAD 400T GW 075559
NEOMIG-I 400 G 075085
IMS NEOMIG-I 400 G 077478
NEOMIG-I 500 G 075092
IMS NEOMIG-I 500 G 077485
DESCRIPTION OF THE EQUIPMENT (I)
Support plate (K1174)
1-
Digital connector
Some configurations do not require all the elements of the Kit.
INSTALLATION
WARNING
ELECTRIC SHOCKS CAN BE FATAL
Only experienced personnel authorised by the manufacturer may carry out the installation. During installation, make sure
that the generator is disconnected from the mains.
To connect the kit to the welding machine, see page 2 onwards.
Any access to internal areas beyond the areas described in this video guide is prohibited and voids the warranty and any other form of support. In-
deed, these manipulations may be damaging to the parts and/or the internal electronic components of the product.
Translation of the original
instructions
2- RJ45 cable - 750 mm
KIT NUM-3
7