EGO ST1511E Manual De Instrucciones página 17

PROBLEM
Trimmer head will not
advance line
Grass wraps around
trimmer head and
motor housing
The blade is not cutting
the line.
Cracks on the trimmer
head or the spool
retainer comes loose
with spool base.
During line replace-
ment, the line can't be
loaded into the trimmer
head properly.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
CAUSE
◾
The motor shaft or trimmer head
is bound with grass.
◾
There is not enough line in the
spool retainer.
◾
The trimmer head is dirty.
◾
Line is tangled in the spool
retainer.
◾
The line is too short.
◾
Cutting tall grass at ground
level.
◾
The line-cutting blade on the
edge of the guard has become
dull.
◾
The trimmer head is worn out.
◾
Spool retainer's LOAD lines do
not align with the eyelets in the
spool base.
◾
The string line is not correctly
inserted into the mounting hole
in the eyelet.
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E
SOLUTION
◾
Stop the trimmer, remove the battery, and
remove the grass from the motor shaft and
trimmer head.
◾
Remove the battery and replace the cutting
line; follow the section "LINE REPLACEMENT"
in this manual.
◾
Remove the battery and clean the spool retainer
and spool base.
◾
Remove the battery, remove the line from the
spool retainer and rewind; follow the section
"LINE REPLACEMENT" in this manual.
◾
Remove the battery and pull the lines while
alternately pressing down on and releasing the
trimmer head.
◾
Cut tall grass from the top down, removing
no more than 20cm in each pass to prevent
wrapping.
◾
Sharpen the line-cutting blade with a file or
replace it with a new blade.
◾
Replace the trimmer head Immediately
performed by a qualified service technician.
◾
Rotate the spool retainer in the arrow direction
to align the LOAD lines on the spool retainer
with the eyelets in the spool base.
◾
Align the LOAD lines with the eyelets first, then
insert the line into the mounting hole inside
the eyelet.
EN
17