EGO ST1511E Manual De Instrucciones página 11

◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used;In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
PACKING LIST
PART NAME
Line Trimmer
Guard
Front-assist Handle Assembly
Shoulder Strap
Hex Wrench
Operator's Manual
Cutting line
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A)
1. Rear Handle
2. Switch Trigger
3. Lock-off Button
4. Adjustable Front-assist Handle
5. Shoulder Strap
6. Shaft
7. Guard
8. Battery-release Button
9. Latch
10. Electric Contacts
11. Ejection Mechanism
12. Trimmer Head (Bump Head)
13. Line-loading Button
14. Cutting line
15. Release Tab
16. Line-cutting Blade
17 Hexagon Wrench
ASSEMBLY
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
or create accessories not recommended for use with
this Line trimmer. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
QUANTITY
cause serious personal injury, always remove the battery
1
pack from the tool when assembling parts.
1
MOUNTING THE GUARD
1
1
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
1
1
guard firmly in place. The guard must always be on the
1
tool to protect the user! When the guard is fixed, never
attempt to remove or adjust the guard, if a replacement
is needed, it should be performed by a qualified service
technician!
Align the two bolts, which are pre-assembled on the guard,
with the two screw holes in the shaft (Fig. B), and then
tighten them with the supplied hex wrench(Fig. C).
Make sure the guard is fixed according to Fig. B & C, any
reverse fixing will cause great danger!
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
Push the front-assist handle onto the shaft (Fig. E), then
insert the clamping block into the handle slot (Fig. F), mount
the locking pole, and clamp them with the wing nut
(Fig. G). The sequence is as Fig. D shown. Lastly, adjust
the front-assist handle between the soft sleeve and the
label to make sure your front arm is straight when using
the trimmer (Fig. H) and then lock the lever of the locking
pole (Fig. I).
Fig. D & H parts description see below:
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E
WARNING:
If any parts are damaged or missing,
WARNING:
Do not attempt to modify this product
WARNING:
To prevent accidental starting that could
WARNING:
Always wear gloves when mounting or
WARNING:
Never operate the tool without the
D-1 Front-assist Handle
D-2 Locking pole
D-3 Clamping Block
D-4 Wing Nut
H-1 Soft Sleeve
H-2 Warning Label
11
EN