Publicidad
Idiomas disponibles
Idiomas disponibles
English
Hardware Installation
Note: Make sure your mainboard has a Mini PCIe port with PCIe interface.
1.
Turn off your PC and unplug the power cord.
2.
Open the housing.
3.
Insert the module into a free Mini PCIe slot and screw the module. (different
motherboards may have different fixing options)
4.
Now you can connect your SATA devices with the module, by the help of
existing cables.
5.
Reattach the housing and connect the power cord to the AC adapter.
Driver Installation
1.
Switch on your computer.
2.
Put the driver CD in the CD ROM drive.
3.
Afterwards, Windows displays the Hardware wizard.
4.
Follow the instructions of the driver installation.
5.
In case the assistant should not start automatically, please start the
Setup.exe from the driver CD.
6.
Navigate to: CD-drive\ASMedia\ASM106x\Windows\Setup.exe.
7.
Follow the instructions of the driver installation.
8.
Restart your system after the installation.
9.
After restart you can start using the device immediately.
RAID setting
Please note:
If you install and activate a Raid system, make sure you have a full back up of
your present data.
Setup a Raid set with two hard disks installed
Caution: all data in the hard disks will be lost in the following procedures
1.
Turn on the computer, the BIOS on the controller card is executed.
2.
Press Ctrl-R to enter into BIOS menu.
3.
Choose "Select Configure Controller" in the Main menu. Confirm with "enter".
4.
Choose "RAID0", "RAID1" or "SPAN" depending on your application.
5.
Now type "Y" to confirm or "N" to cancel and confirm the entry with "enter".
Then the configuration is started.
6.
After completion, the message "Mode Change is completed" appears.
7.
Press "Esc" to exit.
-3-
Publicidad
