Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
3.
Incline the machine to an angle of 40° and let the side with right-angle notch face towards
front of the washing machine, as shown in the figure. Insert the side with oblique-angle
notch between two foot screws at back of the washing machine completely in place.
Then, install the bottom plate and ensure that it contacts with bottom of the washing
machine closely.
4.
Press the double sided tape on four sides manually to secure the noise-reduction palte
to the machine body firmly.
Connect the water supply inlet hose
1.
If the water inlet hose is not already installed, it must be screwed to the appliance. The
blue marked hose is only for cold water.
2.
Screw by hand the inlet hose onto the tap, tightening the nut.
Attention:
•
No kinks in the hose!
•
The appliance must not be connected to the mixing tap of an un-pressurized
water heater.
•
Check water-tightness of connections by turning the tap completely on.
•
If the hose is too short, replace it with a suitable length of pressure resistant
hose (1000 kPa min).
•
Check the inlet hose regularly for brittleness and cracks and replace if
necessary.
•
The washing machine can be connected without a non-return valve.
PUMP
10
EN
Publicidad
