Descargar Imprimir esta página

Allen + Roth WS64-1BRZ Instrucciones página 7

Lámpara de pared

Publicidad

Idiomas disponibles

Idiomas disponibles

PLUG-IN ASSEMBLY INSTRUCTIONS
Remove cord lock (H) from cord
3.
preassembled on fixture (A). Use a flathead
screwdriver (not included) and gently push
screwdriver into small hole in front part of cord
lock (H). Release front and back parts of cord
lock (H).
Set aside front and back of cord lock (H) for
later use.
4.
Determine the location for the cord lock (H).
Place the back part of the cord lock (H)
against the wall and mark the location of the
screw hole using a pencil or a marker (not
included). Set cord lock (H) aside.
Using a 1/8 in. drill bit (not included), drill a
pilot hole at the marked location. Gently tap a
wall anchor (DD) with a hammer (not included)
until flush with wall surface.
Secure back of cord lock (H) to wall with one
wall anchor screw (CC). Thread cord through
slot in back part of cord lock (H). Replace front
of cord lock (H), making sure the tabs close.
Proceed to Step 7 on page 10 (FINAL
ASSEMBLY INSTRUCTIONS) to complete
installation.
Hardware Used
Wall Anchor Screw
CC
Wall Anchor
DD
3
H
(Front)
4
CC
H
(Front)
x 1
x 1
7
Cord
H
H
(Back)
Cord
H
DD
(Back)
Wall

Publicidad

loading

Este manual también es adecuado para:

5024118