Mark MRACK 12E Manual Del Usuario página 5

8. AUX1 and AUX(2/FX)
AUX1 knob controls the signal level sent from this channel to AUX1 BUS.
AUX(2/FX) knob controls the adjust of signal level sent to the AUX bus and FX BUS (built-in in effects).
The same signal level is sending to the AUX and FX buses connected to these knobs.
9. PAN knobs
This knob adjusts the volume balance of each channel sent to the MAIN BUS. If the BUS assign switch
(1-2) is pressed, this knob adjusts the volume balance sent to the GROUP BUS.
10. MAIN switch
Turn this switch on assigns the channel's signal to the MAIN BUS.
11. G(1-2) switch
Assigns the channel's signal to the GROUP 1-2 BUSES.
12. PFL switch
When the PFL switch is on the channel pre-knob signal is output to PHONES jack for monitoring.
When a PFL switch is turned on the PFL indicator below the level meter flashes.
13. Channel knobs
For adjusting the level of the channel signal. Use this controls to adjust the balance between the
various channels.
4