Lumisky 2X BLINKY Manual De Instrucciones página 4

2X BLINKY
Contents of the pack:
I Solar wall light X1
Manual
instruction
II Installation gauge X1
III Instruction Manual X1
IV Installation hardware X 1 set
The product's solar panel charges the built-in rechargeable battery in 5-6 hours. During the day,
the solar panel converts sunlight into electricity, then automatically turns on for 6-8 hours after
dark. All you need to do is turn it on, install it in the places you need and admire the light at
night.
Features :
Featuring 4 LEDs and a reflective lens
5 volt solar panel
3.7 volt rechargeable battery
Set up :
Your bright solar wall light is ready to use since it arrives already assembled!
1. Place the installation gauge (included) in the places where you want to install the light, drill
two holes (about 72.5mm apart), insert the expansion pillar and screws, screws must protrude
from the wall.
3-5mm. Hang the product on the screws.
2. Press the ON/OFF power switch once to turn it on, when it comes to OFF mode (the switch is
at the bottom of the light, refer to FIG 3).
3. Sit back and enjoy the soft ambient light of the night.
Note: Place it away from porch lights or other light sources, as bright lights may prevent it from
turning on automatically. Place the solar street light in locations where it can receive 5-6 hours
of direct sunlight per day.
4