klover STARBOX UP Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 46

EN
- attach the profile (3) with the screws provided to close the front
combustion air inlet.
6.6 CONNECTION TO THE FUME EXHAUST
a
We recommend carefully reading the chapters
mum safety clearances" and
The appliance is standard-configured with the fume exhaust on the
top (Su).
a
To connect the fume exhaust to a stainless steel
pipe, it may be necessary to use a dedicated fitting;
if this is the case, consult the specifications of the
steel pipe manufacturer.
16
x2
4
Fig. 13
"Mini-
"Flue gas channel".
Su
Fig. 14
6.7 INSTALLING THE KIT
6.7.1 FRONT VENTILATION KIT
To install the kit, proceed as follows:
- Remove the covering completely; consult
- remove the pre-cut closing caps (1) and the upper shell (2)
- mount the upper filler profile (3) and the new upper shell (4)
2
1
- mount the two new plates (5) already equipped with fans and adapt-
er, fastening them with the screws provided with the kit.
5
5
INSTALLATION
"Covering removal"
1
3
4
Fig. 15
6 x2
Fig. 16
CS.VES.IST-1_EN_Rev. 0.0_09-23