JENN-AIR JGC8430 Manual De Instalación página 4

2. IFTHIS ISA30" WIDE COOKTOP AND AJENN-AIR, MODEL JJW85XX, JJW95XX, W27100X, OR W132X, ELECTRIC WALL O VEN I STO BE
INSTALLED BELOW T HIS COOKTOR
NOTE1: This applianceand its gasandelectricalsupplysourcesmustbe
installed beforethe waltoven isinstalled.Seeillustration ( Electrical W iring
Information- page 6; figure6) for recommended electricalsupplysource
locations.
NOTE2: It may be necessary to extendgassupplypipingfor thisappliance
intoadjacentunder-counter c abinetrywhen a wall ovenisinstalled below
this appliance.
Join a 1/2" NPT pipe elbow (locallyavailable)to the malethreads at the
manifoldentrance.Whenjoined, causethe open threadsof the elbowto
facetowardtheleft sideofthe appliance. I nstallthe appliance in itscounter
cutout.
Joina 1/2" NPT pipe nippleto the elbowusinga pipe sectionof sufficient
lengthto extend,horizontally,beyondthe left side of the wall oven. (To
accomplish this it maybe necessary to extend the pipesectionintoadjacent
cabinetry.) Join additional 1/2" NPT elbow(s) and pipe nipples, as
necessary, t o accomplish the following:
Join the outlet of the appliance pressure regulatorsupplied with this
applianceto the male threads of the newly installed gas supply piping.
Installtheapplianceregulatorina locationwhichwill be accessiblebeside
or belowthe wall oven. Insurethe applianceregulatorisinstalledwith its
directionalarrowpointingin the directionofgasflow.Tightentheappliance
regulatorto 20 to 30 ft-tbs of torque.
I IMPORTANT approved
Nevertightento morethan35 ft-tbs of torque.Alwaysuse an
pipe joint compoundresistantto the action of LP gas.
Locateandjoin a manualshut-offvalvein an accessiblelocationinthe gas
line aheadof the applianceregulatorand externalto the appliancefor the
purposeof turningon or shuttingoff gasto the appliance.
Makeadditional p ipe connections as necessary aheadoftheshut-offvalve
to the gas supplysource.Assureall pipe joint connections are gas tight.
IMPORTANT
Applya non-corrosive leakdetectionfluidto all jointsand fittings inthe
gas connectionbetweenthe supply line shut-offvalve and the range.
Includegasfittings andjoints in the rangeif connections weredisturbed
during installation.Checkfor leaks!Bubblesappearingaroundfittings
andconnections wilt indicatea leak.If a leakappears, t urnoff supplyline
gasshut-offvalve,tighten connections, t urnon the supply linegas shut
off valve, and retestfor leaks. Nevertest for gas leaks with an open
flame.
ILLUSTRATIVE GAS SUPPLY PIPING
(WALLOVENINSTALLEDBELOW30" COOKTOP)
J BURNER BOX
J _ (REAROF APPLIANCE)
MANIFOLD
_I[_ENTRANCE
J
PIPING PASSES THROUGH DIVIDING
_IALL BE3_NEEN ADJACENT CAB NETS
• NIPPLES
(Lengths
I to suit)
I I ALL PIPE JOINTS 1/2 N.RT,
APPLIANCE MANUAL
I PRESSURE SHUTOFF
REGULATOR VALVE
INLET
APPROXIMATE CROSS SECTION
PROFILE OF WALL OVEN
FIGURE4
Note, regardingFigure4, above:
• For conveniencein servicea ground joint union (not shown: locally
available)shouldbe included in the piping illustrated i n figure 4, in a
locationmostpractical f orthe installation. Generally, a practical l ocation
isinthecabinetbelowthis appliance, n earthe manifold entrance,rather
than in an adjoiningcabinet.
• If the alternativepiping methodshown in figure 5 is selectedfor the
installation, no groundjoint union is required.(Theflexible appliance
connectorillustrated p rovides the unionjoints necessary for servicing.)
When a dividingwall is presentand a flexible connectoris usedit is
recommended for convenience,in both installation a nd service, the
flexible connector,itself,passthroughthe dividingwall. Any flexible
connectorused with this appliancemustsatisfyall requirements
statedin the text accompanying figure 5.