Caterlite BW002 Manual De Instrucciones página 5

Caution:
• Do not let the mixer run continuously for more than 5 minutes to avoid overheating.
Ensure to let the mixer rest for at least 20 minutes between consecutive cycles.
• During mixing, never let the beaters or dough hooks face towards people or objects.
Risk of damage or injury!
• Never add ingredients into the container during mixing.
5. During operation, you can also press the "TURBO" button to mix with the highest speed. In turbo
mode, do not let the motor run for more than 1 minute.
6. After mixing, turn off the mixer by setting the speed selector to "0", then disconnect from power
supply and let cool completely.
7. To remove the beaters or dough hooks, hold them with one hand and press the Eject button with the
other hand.
Removing the lodged food
If a piece of food gets lodged onto the attachments, please follow the instructions below:
1. Turn off mixer, disconnect from power supply and let it come to a complete stop.
2. Press the Eject button to release the attachments.
3. Use a rubber/wooden spatula to carefully remove the food lodged.
Cleaning, Care & Maintenance
Always turn off the mixer and disconnect from power supply before cleaning.
•
• Never put the mixer body in water or let the body, cord or plug get wet.
• Use warm soapy water to clean the mixing attachments. Do not use abrasive cleaning chemicals as
these can leave harmful residues. The mixing attachments are dishwasher safe.
• Clean the exterior of the appliance with a slightly damp cloth.
• Dry all parts thoroughly after cleaning.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is The unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains Power supply fault
Mixer slows down Too many contents in the mixing
container, and unit runs at speed
setting 1 for too long time
Wrong mixing attachment used
Loud noise Mixing attachments not correctly
fitted
Mixing attachments deforms
BW002_ML_A5_v2_20230615.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check Mains Power supply
Turn off the mixer and remove some of the
contents. Adjust the food formula if needed
Select suitable attachment
Remove and refit attachments
Consult a qualified Technician
EN
5
2023/6/15 16:52:09