mspa Tekapo C-TE062 Manual De Instrucciones página 9

SPA SET-UP
1
4
YELLOW
HEATER
BUBBLE
UP
Press it again to stop inflation when the
YELLOW
manometer points to the
NOTE: Your spa will require additional air to be added from time to time. Changes in temperature from day to night will change the pressure in the spa and
may cause a certain amount of deflation.
IMPORTANT: ALWAYS READ THE MANOMETER TO ENSURE THAT THE SPA IS FILLED AT THE CORRECT AIR PRES-
SURE FOR THE CONDITIONS.
YELLOW
YELLOW
GREEN
2
Make sure the inflation hose is properly installed as pictured above.
5
FILTER
TIMER
DOWN
section.
Ensure the manometer points to the Yellow section in the following conditions
●
After inflation, before filling the water.
●
When leaving the spa outdoors unattended for long periods of time at a temperature higher than 20°C (68°F).
Ensure the manometer points to the Green section in the following conditions
●
When the spa is filled with water.
●
When the spa is in use.
WARNING: If the manometer points to the White section, the air pressure of your spa is too high.
Press the black button on the bottom of manometer to release some air until the pointer returns to the Green
or Yellow section.
Disconnect the inflation. Rotate the air valve cap back.
9
3
°C
°F
BUBBLE
UVC
HEATER FILTER
BUBBLE TIMER
UP DOWN
Press the BUBBLE button for inflation.