JCB -18CS Instrucciones De Funcionamiento página 8

TOOL SPECIFIC SAFETY WARNINGS
Wear ear protectors.
m
can cause hearing loss.
Wear eye protection.
m
to prevent eyes from exposure to flying
particles.
Wear dust mask.
m
measures against inhalation of dust. Some
materials can contain toxic materials. Also
work with dust/ chip extraction when
connectable.
Additional Safety Rules For Saw
Tools
Cutting Procedures
Keep hands away from cutting area
m
and the blade. Keep your second
hand on auxiliary handle, or motor
housing. If both hands are holding the saw,
they cannot be cut by the blade.
Do not reach underneath the
m
workpiece. The guard cannot protect you
from the blade below the workpiece.
Adjust the cutting depth to the
m
thickness of the workpiece. Less than a
full tooth of the blade teeth should be visible
below the workpiece.
Never hold the workpiece in your
m
hands or across your leg while
cutting. Secure the workpiece to a
stable platform. It is important to support
the work properly to minimise body
exposure, blade binding, or loss of control.
JCB-18CS
Instruction & User Manual
Exposure to noise
Wear goggles
Take protective
Hold the power tool by insulated
m
gripping surfaces, when performing
an operation where the cutting tool
may contact hidden wiring or its own
cord. Contact with a "live" wire will also
make exposed metal parts of the power
tool "live" and could give the operator an
electric shock.
When ripping, always use a rip fence
m
or straight edge guide. This improves
the accuracy of cut and reduces the chance
of blade binding.
Always use blades with correct size
m
and shape (diamond versus round) of
arbour holes. Blades that do not match
the mounting hardware of the saw will run
off-centre, causing loss of control.
Never use damaged or incorrect
m
blade washers or bolt. The blade
washers and bolt were specially designed
for your saw, for optimum performance and
safety of operation.
Kickback Causes And Related
Warnings
Kickback is a sudden reaction to a pinched,
m
jammed or misaligned saw blade, causing
an uncontrolled saw to lift up and out of the
workpiece toward the operator
When the blade is pinched or jammed
m
tightly by the kerf closing down, the blade
stalls and the motor reaction drives the unit
rapidly back toward the operator
7