Publicidad
Idiomas disponibles
Idiomas disponibles
particles are not harmful and will disappear after a while.
·
When you turn the appliance on, the steam generator may make a pumping noise. This is normal. This
sound is a sign that water is being pumped into the steam generator.
·
While heating up the soleplate, a little steam will automatically come out of the soleplate. This is also
normal and will last about 3 seconds.
USE
This steam generator offers 2 options: dry ironing or steam ironing. To do this, follow the instructions
below. Also carefully read the ironing tips at the bottom of this section before using the appliance.
DRY IRONING
1.
Place the iron on the thermal insulation pads.
2.
Insert the plug into the wall socket. Turn the temperature dial to the
desired setting, depending on the type of fabric to be ironed. The
iron will start to heat up. The temperature indicator light will start to
illuminate.
3.
When the temperature indicator light goes back off, the selected
temperature has been reached. You can now start ironing.
4.
After ironing, place the iron on the thermal insulation pads. Turn
the temperature dial back to 'MIN' to switch off the appliance. The
temperature indicator light will now turn off. Remove the plug from the wall socket. Let the
appliance cool down completely.
Caution: never touch the hot ironing soleplate!
IRONING WITH STEAM
Caution: do not plug in yet.
1.
Fill the water tank with water, being careful not to exceed the
maximum level (1.2 l). Use only tap water or 50% tap water and 50%
demineralised water in case of hard water.
2.
Slide the water tank back into the appliance.
3.
Place the iron on the thermal insulation pads. Plug the plug into the
socket. Turn the temperature dial until it reaches the area where steam
can be requested (see symbol on temperature dial), otherwise water
droplets will come out of the soleplate due to condensation. The
temperature indicator light will start to come on.
4.
When the temperature indicator light goes out again, the appliance has reached the correct
temperature.
5.
To iron with steam, press the steam button on the inside of the handle of the iron. A continuous
stream of steam will be sprayed from the soleplate. When you release the button, iron again dry,
without steam.
CAUTION:
Never touch the hot iron soleplate!
Never direct the steam at people!
www.domo-elektro.be
35
DO7119S
Publicidad
