Publicidad
Idiomas disponibles
Idiomas disponibles
·
Clean the upper part of the iron with a soft, damp cloth.
·
Wipe away drips on the steam generator and clean the thermal insulation pads with a dry cloth.
·
If you do not use the steam generator for a long time, pour the water out of the water tank and put the
iron on the thermal insulation pads for storage.
ATTENTION: Use only tap water (or 50% tap water and 50% demineralised water in case of hard water)
in the steam generator. Caution: 100% softened or demineralised water should be avoided! Using a
"softener" and/or scented water may cause brown stains, resulting in damage to the steam chamber.
DECALCIFY
Descale the steam generator regularly to extend the life of the appliance and
to maintain proper operation. To do this, follow the instructions below:
1.
Fill half of the water tank with a mixture of 1/3 vinegar and 2/3 water.
2.
Plug in and turn the temperature dial to 'dry ironing'.
3.
The temperature indicator light will come on to show that the appliance
is heating up. Wait for the appliance to heat up and hold the iron over a
sink or sink.
4.
Now hold down the steam button for one minute so that you produce
continuous steam. The appliance will clean itself in this way.
CAUTION: take care not to come into contact with the hot steam to avoid burns!
5.
After this, fill the water tank with water only. Turn the temperature dial to the maximum and wait for
the appliance to reach temperature. Repeat this cycle of spraying steam 2 to 3 times, but this time
with just water, until the vinegar smell has disappeared.
PROBLEM AND SOLUTION
Problems
Possible causes
The appliance
1. The set temperature is too low.
leaks water from
2. The iron is not hot enough.
the holes in the
3. You use the steam button too often.
ironing soleplate.
Brown liquid
1. You are using chemical
comes out of the
limescale remover.
ironing soleplate.
2. There are dust fibres in the sole-
plate that have been burnt.
3. Your laundry has not been rinsed
adequately or you are using starch.
4. Demineralised water was used.
The ironing
1. You are using a too high
soleplate is dirty or
temperature.
brown .
2. You are using starch.
www.domo-elektro.be
Solutions
1. Set the temperature dial within the
margins of the steam symbol.
2. Wait for the light to go out.
3. Wait a few seconds before pressing
the button again.
1. Do not use limescale remover.
2. Clean the sole with a damp sponge.
3. Check that your laundry has been
sufficiently rinsed.
4. Use only tap water or 50/50 tap water/
demineralised water.
1. Clean the soleplate with a damp
sponge.
2. Spray the starch on the inside of the
laundry.
37
DO7119S
Publicidad
