Publicidad
Idiomas disponibles
Idiomas disponibles
■
The
manufacturer
connect to a power socket protected by an
RCD with a trip of 30 mA or less.
BLOWER SAFETY WARNINGS
■
Operate the product only at reasonable
hours – not early in the morning or late at
night when people might be disturbed.
■
Never operate the product in an explosive
atmosphere.
■
Avoid using the product in bad weather
conditions, especially when there is a risk
of lightning.
■
Do not operate in poor lighting. The
operator requires a clear view of the work
area to identify potential hazards.
■
Operating similar tools nearby increases
both the risk of hearing injury and the
potential for other persons to enter your
working area.
■
Always be sure of the footing on slopes.
Walk, never run.
■
Keep proper footing and balance. Do not
overreach. Overreaching can result in loss
of balance.
■
Never use the product with defective
guards or shields, or without safety devices
in place.
■
Keep the power source clear of debris and
other accumulations to prevent damage to
the power source or possible fire.
■
Do not modify the product in any way or
use parts and accessories which are not
recommended by the manufacturer.
WARNING
If the product is dropped, suffers heavy
impact, or begins to vibrate abnormally,
immediately stop the product and inspect
for damage or identify the cause of the
vibration. Any damage should be properly
repaired or replaced by an authorised
service centre.
■
To reduce the risk of injury associated with
contacting rotating parts, always stop the
product, and disconnect from the power
supply (if applicable), and make sure all
moving parts have come to a stop before:
–
leaving the product unattended
–
clearing blockages
recommends
you
–
checking, cleaning, or working on the
product
–
inspecting the product after striking a
foreign object
■
Immediately switch off the product and
disconnect from the power supply in the
event of accident or breakdown. Do not
operate the product again until it has been
fully checked by an authorised service
centre.
■
Wear a face filter mask in dusty conditions
to reduce the risk of injury associated with
the inhalation of dust.
■
Slightly
dampen
conditions.
■
Do not use the product near open windows.
■
Never place objects inside the blower
tubes.
■
Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
■
Do not point the blower nozzle in the
direction of people or pets.
■
Do not place blower on top of or near loose
debris. Debris may be sucked into intake
vent resulting in possible damage to the
product.
TRANSPORTATION AND STORAGE
For assembling with petrol-driven power
head
■
Stop the engine and allow it to cool before
storing or transporting.
■
Clean all foreign material from the product.
■
Drain all fuel from the tank into a container
approved for petrol. Remember to properly
replace and tighten the fuel cap.
■
Run the engine until it stops, this will
remove all fuel that could become stale and
leave varnish and gum in the fuel system.
■
If applicable, drain all lubricant from tank
into a container approved for lubricant.
Remember to properly replace the lubricant
cap.
■
Store the product in a cool dry and well-
ventilated place that is inaccessible to
children. Keep away from corrosive agents,
such as garden chemicals and de-icing
salts.
■
Do not store outdoors.
surfaces
in
dusty
English |
3
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
Publicidad
