Ultra Reef Akula UKS-160 Manual De Instrucciones página 20

PUMPS WITH CONTROLLER (Sicce)
Adjusting of the pump allows you to change the
performance of the skimmer by simultaneously adjust
the amount of aspirated air and treated water.
Warning: Each time the pump is switched on, it will run
for the first 120 seconds at minimum speed (only one
speed LED flashing). After this time, it will return to the
last set speed.
Attention: Set the speed to 50% at the first start and
wait 24 hours before further adjustments.
Reducing the pump speed decreases the extraction
capacity and the consumption of the skimmer. This
solution is useful for feeding or tanks maturation time.
Conversely, increasing the speed of the pump increases
the extraction capacity and the consumption of the
skimmer.
After each variation of speed, it is necessary to wait for
the foam to stabilize. Change the speed of one step
(one LED) every 2 hours.
USE OF THE CONTROLLER (Sicce)
To turn on the pump, keep the (+) key pressed for 3".
As a test, all the LEDs light up for a few seconds. The
pump starts at 30% of the operating range.
By pressing the (+) and (-) keys, it is possible to increase
or decrease the pump flow. Consequently, the light
intensity of the five LEDs will vary.
To turn off the pump, keep the (+) key pressed for 3".
The supplied Controller can only regulate the flow, can
only be powered with the supplied transformer, and
manages only the supplied pump. Any other use could
irreparably damage the device and void the warranty.
APP CONTRALL
The pump symbol will light up in the colour set through
the CONTRALL application.
The Wi-Fi symbol flashes blue slowly because it is
waiting to be connected to the Wi-Fi network via the
CONTRALL app.
If the pump is managed through the CONTRALL
application, it will not be possible to change its
operation using the controller. It will only be possible to
turn it off by keeping the (+) key pressed for 3".
Configuration via APP CONTRALL:
1. Download the CONTRALL application for free.
2. Select MY DEVICES and press the + symbol at the
top right.
3. Select PSK SDC and Model 3.0 or 2600-4000.
4. Read the text and press PROCEED.
5. Identify the Wi.Fi network to which you want to
connect the pump and enter the network
password
6. Register the pump with a name and press DONE.
9
ULTRA REEF
www.ultrareef.it