Husqvarna 128CD Manual Del Usuario página 12

CAUTION:
more than 10% ethanol concentration
(E10). This can cause damage to the
product.
CAUTION:
gasoline. This can cause damage to the
product.
• Always use new unleaded gasoline with a
minimum octane number of 90 RON (87 AKI)
and with less than 10% ethanol concentration
(E10).
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
• Always use a good quality unleaded gasoline/oil
mixture.
Two-cycle engine oil
• Use only high quality two-cycle engine oil. Use
only an air cooled engine oil.
• Do not use other types of oil.
• Mixture ratio 50:1 (2%)
Gasoline
1 U.S. Gal.
1 UK Gal.
5 l
To make the fuel mixture
Note:
Always use a clean fuel container when you
mix the fuel.
Note:
Do not make more than 30 days quantity of
fuel mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
• Always use a fuel container with an antispill
valve.
• If there is some fuel on the container, remove the
unwanted fuel and let the container dry.
• Make sure that the area near the fuel tank cap is
clean.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
12
Do not use gasoline with
Do not use leaded
Oil
77 ml (2,6 oz)
95 ml (3,2 oz)
100 ml (3,4 oz)
To start and stop
To examine before an engine start
• Examine the product for missing, damaged,
loose or worn parts.
• Examine the nuts, screws and bolts.
• Examine the air filter.
• Examine the throttle trigger lockout and the
throttle control for correct operation.
• Examine the stop switch for correct operation.
• Examine for fuel leaks.
To start a cold engine
1. Push the air purge bulb 10 times. (Fig. 30)
2. Move choke control to the full choke position.
(Fig. 31)
3. Hold the body of the product on the ground with
your left hand. Do not step on the product. Pull
the starter rope handle slowly until you feel some
resistance. (Fig. 32)
Note:
Do not pull the throttle trigger while you
start the engine.
4. Pull the starter rope handle 3 times with force.
CAUTION:
starter rope until it stops. Do not
let go of the starter rope when it is
fully extended. Release the starter
rope slowly. Failure to obey these
instructions can cause damage to the
engine.
5. Move the choke control to the half choke
position.
6. Pull the starter rope handle until the engine
starts.
7. Let the engine run for 10 seconds.
8. Move the choke control to the no choke position.
To start a warm engine
1. Slowly push the air purge bulb 10 times.
2. Move the choke lever to the HALF CHOKE
position.
3. Pull the starter rope handle quickly until the
engine runs.
4. Move the choke lever to the NO CHOKE
position.
To stop the product
• Push the stop switch to stop the engine. (Fig. 33)
Note:
The stop switch automatically goes back to
its initial position.
Do not pull the
215 - 005 - 04.09.2023