Grip Rite GRTBN200N Manual Del Operador página 17

PROBLEM
Tool operates, but no fastener
is driven.
Tool won't operate - nail jammed
in tool nose, preventing tool
from operating.
Tool leaks air.
TOOL CHECKS
Keep your nailer in top working condition by checking it daily. See your Grip-Rite
for service if part or operating problems are found. Never use a malfunctioning tool -
it could result in serious injury.
Workpiece Contact & Trigger
Check workpiece contact for proper operation before each use. Workpiece contact
must move freely and return to extended position when lifted from workpiece.
Trigger must operate freely.
Daily Inspection
• Check for broken, damaged, or excessively worn parts, and repair or
replace as needed.
• Check for air leaks at trigger, cap, and nose. Disconnect tool from air supply
immediately if leaks are present, and see dealer for service.
• Make sure all screws are tightened securely.
FASTENER DRIVING PROBLEMS
Check magazine for jammed fastener. Clear
jam and reload magazine. Check staple strip
for smooth feeding in magazine.
Remove jammed fastener. Check magazine
for incorrect, bent, or loose fasteners, and
discard. Reload using Grip-Rite
Check for source of leak, and tighten fittings
and screws as required. Discontinue using
tool if air leaks at trigger area or from cap
exhaust. Contact your dealer.
17
TROUBLESHOOTING
CORRECTIVE ACTION
nails.
®
dealer
®