Publicidad
Idiomas disponibles
Idiomas disponibles
ADDITIONAL SAFETY RULES FOR TILLERS
For your safety and the safety of others, please pay special attention to these precautions.
•
This tiller is designed to give safe and dependable service if operated according to instructions.
•
Read and understand the owner's manual before operating the tiller. Failure to do so could result in
personal injury or equipment damage.
•
Exhaust gas contains poisonous carbon monoxide.
•
Never run the tiller in an enclosed area.
•
Be sure to provide adequate ventilation.
•
When installed, ventilated protection is to be observed.
•
The rotating parts are sharp and they turn at high speed. Accidental contact can cause serious injury.
•
Keep your hands and feet away from the parts while engine is running.
•
Stop the engine and disengage the tines clutch before inspection or maintenance of tires.
•
Disconnect the spark plug cap to prevent any possibility of accidental starting. Wear heavy gloves to
protect your hands from the tines when clearing the tines or when inspecting or replacing the tines.
PETROL SAFETY WARNINGS
WARNING: Use extra care when handling fuels. They are inflammable and the vapours are potentially
explosive. The following points must be observed.
•
Use only an approved container.
•
Never remove the fuel cap or add fuel when the engine is running. Allow engine exhaust components
to cool before refuelling.
•
Do not smoke.
•
Never refuel the machine indoors.
•
Never store the machine or fuel containers in places where there is a naked flame, such as a water
heater.
•
If fuel is spilt, do not attempt to start the power source before moving the machine away from the
spillage area.
•
Always replace and securely tighten the fuel cap after refuelling.
•
Whenever the tank is drained, this should be done outdoors.
Pre-Start Inspection
•
Make sure all safety guards are in place and all nuts and bolts are secure.
•
Check oil level in engine crankcase.
Only use motor oil (15W40/<0°C: 5W30).
Important! Engine is shipped from the factory without oil. You must add engine oil before starting
engine.
•
Inspect air filter for cleanliness.
•
Check the fuel supply. Do not fill gas tank completely full, allow space for fuel to expand.
•
Be sure spark plug wire is attached and spark plug is tightened securely.
•
Check depth regulator lever position.
•
Examine underneath and around engine for signs of oil or fuel leaks.
•
Inspect fuel hoses for tightness and fuel seepage.
•
Look for signs of engine damage.
•
Remove excessive debris from muffler area and recoil starter.
Start the Engine (B10-B12)
Turn the ON/OFF switch to ON position.
Grasp starter handle and pull out slowly, until it pulls slightly harder.
Pull rope with a rapid full arm stroke until engine runs.
Stop the Engine (B13)
Turn the ON/OFF switch to OFF position.
Normal operation (B14)
The clutch engages and disengages the power from the engine to the transmission.
EN
Publicidad
