Publicidad
Idiomas disponibles
Idiomas disponibles
When the clutch lever is squeezed, before squeeze the clutch. Open the insurance trigger which is below
the clutch first. The clutch is engaged and power is transmitted. Squeeze the lever, the tool will be rotated.
When the lever is released, the clutch is disengaged and power is not transmitted.
Release the clutch lever, the tool will be stopped.
Adjustment
Wheel adjustment (B15-B16)
Pull out the wheel support, and turn to appropriate position.
For moving, turn the wheel to position A.
For working, turn the wheel to position B.
Depth adjustment (B17)
Draw out the B-shape lock and pin, adjust the resistance pole to an appropriate position, then replace the
pin and fix with B-shape lock.
Handlebar adjustment (B18)
Disentangle the fastening bolts on both sides, adjust the handlebar to a suitable position, then tighten the
bolts.
3.4.
Cleaning and maintenance
a)
Use only non-corrosive cleaners to clean the surface.
b)
After cleaning the device, all parts should be dried completely before using it again.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
d)
Do not spray the device with a water jet or submerge it in water.
e)
Do not allow water to get inside the device through vents in the housing of the device.
f)
Clean the vents with a brush and compressed air.
g)
The device must be regularly inspected to check its technical efficiency and spot any damage.
h)
Use a soft, damp cloth for cleaning.
i)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
j)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
k)
The transmission case has grease installed at the factory. We recommend checking the grease level
every month. DO NOT overfill.
l)
Keep all screws, nuts, and bolts tight.
m) For cold weather operation, store the unit in a cool environment. Transferring the unit from a warm to
a cold place can cause the build up of harmful condensation.
Long Term Storage
If your tiller will not be used for more than one month, prepare it for long term storage.
•
Drain the gasoline in the fuel tank and carburettor.
•
Check oil. Remove the spark plug, add a little oil into the cylinder, fit spark plug, rotate the crankshaft
and let oil be well-distributed in the inside surface of the cylinder.
•
Pull the starter rope slowly until you feel resistance, tie a knot to fix the rope, then close the air valve
to keep out the dust and other pollutants.
•
Remove all debris from tiller tines and engine.
•
Store tiller in a clean and dry place.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
Publicidad
