Publicidad
Idiomas disponibles
Idiomas disponibles
Plug Detection
1. Once the display shows "E-3" and "rES", it means the motors are failed to connected with
control unit.
2. Please unplug the main cable, check all connection and make sure all cables are connected
properly, plug the main cable then.
3. Follow the Manual Reset Progress to reset system.
Reset to Factory Setting
1. Keep pressing "S" until the display shows "FAC".
2. Press "S" again to confirm to store the control system to factory setting.
CODE MEANING & TROUBLE SHOOTING
Code
Information
rES
Manual Resetting
Ovr
Over Load
E-2
Anti-Collision Function
Dut
Too Frequent Operation
The Height Difference between
E-4
Two Legs Exceed 1 Inch
E-3
Check the Connection
The function can defect whether the motors are
With this function, you can make the control unit
Operating
Refer to the progress of Manual Reset.
Remove the load on desktop until it less than
1000N (220 lbs) before further operation
It can be used normally after removing the
obstacle.
Make the desk rest for 15minutes before further
operation.
Stop the operation and reset, refer to Manual
reset
Check the cables and ensure they are well
connected, manual reset before re-use
connected properly.
EN
to factory setting.
Publicidad
